635 ROTA TB2 Schnellentlüftung Um die Luft auf dem kürzesten Weg aus dem Zylinder nach außen zu führen, sind beim ROTA TB2 je ein Luftkanal zum Öffnen und Schließen integriert. Die ausströmende Luft muss so nicht mehr über die Profildichtung abströmen, sondern kann auf kürzestem Weg nach außen gelangen. 1 Ausströmende Luft Beim Öffnen des Futters 2 Ausströmende Luft Beim Schließen des Futters Fast ventilation To remove the air from the cylinder via the shortest path, the ROTA TB2 features one integrated air duct for opening and one for closing. The escaping air then no longer has to exit via the air seal ring, but instead is released via the shortest path. 1 Escaping air During opening of the chuck 2 Escaping air During closing of the chuck Optimiertes Schmiersystem Über jeweils einen stirnseitigen Schmiernippel wird jede Grundbacke optimal mit Fett versorgt. Ein intelligentes Verteilungssystem gewährleistet eine gleichmäßige Fettverteilung an allen Gleitebenen der Grundbacke und gewährleistet dauerhaft höhere Spannkräfte. Optimized lubrication system Each base jaw is optimally supplied with grease via a lubrication nipple on the front. An intelligent distribution system ensures even distribution of the grease on all sliding planes of the base jaw for consistently high clamping forces. Druckabfrage über Sensor (optional) Während des Bearbeitens wird der pneumatische Druck im Spannfutter über ein federvorgespanntes Schaltelement überwacht. Fällt der Druck ab, schiebt die Feder den Schaltnocken nach hinten. Der induktive Näherungsschalter erkennt die Position und meldet diese an die Maschinensteuerung. Das entsprechende Montagekit und die Sensoren müssen hierzu separat bestellt werden (siehe Zubehör). 1 Arbeitsdruck Ausreichend vorhanden 2 Druckabfall Wird durch Näherungsschalter erkannt Pressure monitoring via sensor (optional) During machining the pneumatic pressure in the lathe chuck is monitored by a spring-loaded switch element. If the pressure drops, the spring pushes the control cam backwards. The inductive proximity switch detects the position and reports it to the machine control system. The corresponding mounting kit and sensors must be ordered separately for this purpose (see Accessories). 1 Operating pressure Sufficiently available 2 Pressure loss Is detected by proximity switch 1 1 2 2 Pneumatische Kraftspannfutter | Pneumatic Power Lathe Chucks Website: www.bisspecials.com Email: info@bisspecials.com Tel: (0031) 0313 482566 Website: www.bisspecials.com Email: info@bisspecials.com Tel: (0031) 0313 482566 BIS Specials
RkJQdWJsaXNoZXIy NDg1ODE=