36 JBX-2G 200 JBX 300 JBX-2G 300 JBX-2G 400 77652007 77653003 77653009 77654003 50 50 50 100 160 200 200 400 40 50 50 100 30 50 50 90 12087111 13085300 12087111 13085300 12087111 13085300 12087111 13085300 13045300 12044050 12044050 12044050 - 12045051 12045051 12045051 65653007 65653007 65653007 65653007 JBX JBX-2G Manual jaw box SMW-AUTOBLOK standard mounting dimensions Manual jaw box with semi-finished body Application/customer benefits • JBX: Standard mounting dimensions for SMW-AUTOBLOK chucks • JBX-2G: Semifinished body and radial reference key to be adapted by customer • Manual radial setting and clamping of large components on large plates or chuck • Added to chucks there is more gripping force to apply a higher torque on the workpiece • Added to chucks there are more contact points with the workpiece to better distribute the gripping force thus reducing distortion • Very powerful and accurate clamping allowed by strong design • Suitable for vertical machines thanks to the fully protected body • Use of standard hard or soft jaw on top of the master jaw or special frontal jaws on the front side of the master jaw • TONGUE & GROOVE master jaws (type “American Standard”) Technical features • Manual gripping force applied by a strong and protected screw on a strong and rigid master jaw • Manual and fine setting of master jaws for workpiece centering • Protection from contamination with seals along the master jaw profiles • Designed to work on SMW-AUTOBLOK large manual or power chucks or on special plates • Body designed for better chip evacuation Standard equipment Manual jaws box 1 radial key 6 T-nuts and mounting screws (only JBX) Flexibility of use Maximum protection The jaw box can carry both standard or special, hard or soft jaws mounted on the upper side of the master jaw or special jaws mounted on the front side of the master jaw. The jaws on the front side allow optimal clamping in the same axis of the master jaws thus reducing deformation of the jaw and the jaw box. This allows a more rigid and accurate clamping. Also the frontal jaw option increases the flexibility allowing the customer to clamp the component in a very low area where it would be impossible to clamp with traditional jaws mounted on the upper side of the master jaw. Master jaw protected on each side by steel profiles. Maximum protection from the penetration of chips, swarf, rubber and coolant allows less maintenance, working in bad environments and for a longer operative life. Technical data SMW-AUTOBLOK Type Id. No. Jaw stroke (manual setting) mm Max. manual operating torque Nm Max. gripping force kN Weight (without top jaws) kg Hard top jaw (piece)* Id. No. Soft top jaw (piece)* Id. No. Soft top jaw long (piece)* Id. No. Soft top jaw for master jaw front side (piece)* Id. No. Ordering example Qty. 1 / 2 / 3 / 4 manual jaw box JBX 300 Id. No. 77653003 Option: Actuation key Id. No. 11122700 fully sealed – low maintenance proo ine® series * The soft and tempered jaws are not in scope of delivery, the Id. No. are indicated in the table. High precision, resistance and power manual jaw box ■ Accessory for face plates, 4 jaws independent manual or other chucks ■ Internal or external clamping BIS Specials Website: www.bisspecials.com Email: info@bisspecials.com Tel: (0031) 0313 482566 Website: www.bisspecials.com Email: info@bisspecials.com Tel: (0031) 0313 482566
RkJQdWJsaXNoZXIy NDg1ODE=