869 Berechnungsformel: M [Nm] = Fgesamt [N] • H [mm] 1000 • 3 [Backenzahl] Daraus ergibt sich die max. zulässige Gesamtspannkraft bei gegebener Backenhöhe: Fmax-gesamt [N] = M [Nm]• 1000 • 3 [Backen] H [mm] Diese max. zulässige Gesamtspannkraft darf aus Sicherheitsgründen nicht überschritten werden! Die max. zulässige Führungsbahnbelastung finden Sie auf den technischen Seiten des jeweiligen Spannfutters oder in der nachfolgenden Tabelle. Berechnungsbeispiel: Futter: ROTA THW plus 215-66 (Fmax = 82kN) Backe: SFA 200-C5 (Höhe 76 mm) Fmax-gesamt[N] = M [1.230 Nm] • 1000 • 3 [Backen] H [76 mm] = 48.552 N ≈ 48 kN Das heißt, bei der gegebenen Backenhöhe von 76 mm darf die Backenspannkraft nicht mehr als 48 kN betragen! Aufgrund der geringeren Backenspannkraft muss die Drehzahl ebenfalls angepasst (reduziert) werden! Calculation formula: M [Nm] = Ftotal [N]• H [mm] 1000 • 3 [jaws] The result is the max. admissible total clamping force with given jaw height: Fmax-total [N] = M [Nm]• 1000 • 3 [jaws] H [mm] The max. admissible total clamping force can not be exceeded due to safety reasons! The max. admissible jaw guidance load can be found on the technical pages of the individual lathe chuck in the charts following on the next pages. Calculation example: Lathe chuck: ROTA THW plus 215-66 (Fmax = 82kN) Top jaw: SFA 200-C5 (height 76 mm) Fmax-total[N] = M [1.230 Nm] • 1000 • 3 [jaws] H [76 mm] = 48.552 N ≈ 48 kN This means that with given top jaw height of 76 mm the total jaw clamping force can not be more than 48 kN! Due to the low jaw clamping force the max. RPM has to be adjusted (reduced)! Führungsbahnbelastung | Jaw Guidance Load Technik | Technology Website: www.bisspecials.com Email: info@bisspecials.com Tel: (0031) 0313 482566 Website: www.bisspecials.com Email: info@bisspecials.com Tel: (0031) 0313 482566 BIS Specials
RkJQdWJsaXNoZXIy NDg1ODE=