Rego-Fix BIS Specials

Assembling Disassembling Mark on bottom 81 REGO-FIX AG ER System / Product catalog Assembly instructions Finest quality deserves best treatment Correct assembly increases your collet life and ensures low runout TIR. Assembly instructions for ER and ER-UP collets // Insert collet groove into the eccentric ring of the clamping nut at the mark on the bottom of the nut // Push the collet in the direction of the arrow until it clicks in place // Screw the nut with the collet onto the colletholder // We recommend to tighten the nut with a torque wrench. For recommended tightening torque please refer to list on page 157. Disassembly instructions After the nut is unscrewed from the colletholder, press on the face of the collet while simultaneously pushing sideways on the back of the collet opposite the mark, until it disengages from the clamping nut. General advice Never clamp oversized tool shanks. For example, never use a Ø 12 mm to 11 mm collet to clamp a Ø 12.2 mm shank. Rather use the next bigger collet (in this case a Ø 12.5 mm– 11.5 mm or 13 mm– 12 mm collet). Insert tool to the full length of the collet for best results if possible. Also, never insert the tool less than 2 / 3 of the collet length. Improper tool insertion can permanently deform the collet and will result in poor runout. Improper assembly can permanently damage the runout TIR of the collet and may result in the destruction of the clamping nut. Only mount clamping nuts with correctly assembled collets. Expert advice Please only set back-up screw to the tool shank after clamping the tool. Disregar ding this will result i n bad run out and reduced cl amping force. The back-up screw only se rves as protection against a push- back of the tool and must not be used for presetting. Collet groove Eccentric ring Mark on bottom 2.0 ER collets www.bisspecials.com Website: www.bisspecials.com Tel: (+31) 0313 482566 Email: info@bisspecials.com Website: www.bisspecials.com Tel: (+31) 0313 482566 Email: info@bisspecials.com