Rego-Fix BIS Specials

9 REGO-FIX AG PG System / Product catalog XL length toolholders are standard in the REGO-FIX product range and are immediately available. Their long and slim design allows for precise machining even with limited space. Ultimate workmaterial flexibility with powRgrip ® . Even difficult- to-machine materials with high tensile strengths can be machined successfully. Clamp the tool safely and securely by pushing just one button. The clamping will take less than 10 seconds, without the use of heat. At a glance a base stock of tools which remain in the machine. With a 100-piece tool magazine, basic equipment with 60 tools remain in the machine and can be used for approximately 80% of all machining. With this strategy, a greater initial investment had to be made for the basic equipment of the machines. In the long run this way is without a doubt the more sustainable investment. Deicken & Engels has achieved improvements in production with the extra-long powRgrip ® toolholders, which are purchased from REGO-FIX as standard equipment. Even with the pivot-head machines that the company uses, the machining of workpieces is sometimes a challenge. The system is already a great help – but the bar is being constantly raised. If an extension of 400 mm is sufficient today, the customer will assume tomorrow that a standard of 500 mm will be available. In combination with the Coromant Capto interface, the contract manufacturer achieves very good results with extra-long toolholders and optimal results with the standard lengths supplied by REGO-FIX. True fans powRgrip ® has absolutely proven its value at Deicken & Engels. The advantages of the system – perfection and precision – were quickly recognized. Deicken & Engels consider themselves to be big powRgrip ® fans and are convinced that their production is now well-armed for a successful future. 10 sec